Posted by Stuart Pethy on Aug 20, 2018; 8:46am
URL: http://oldforum.flyshooter.com.au/Gun-cleaning-tp5710047p5710059.html

my 2 cents
always use a bore guide and clean after every shoot
carbon remover on wet patches and push through x3 let sit for a few mins
then i dry patch out then a few wet ones again,
scrub with a bronze/brass with carbon cleaner on for about 5 passes and let sit for 5-10mins
patch out
wet patches of copper remover
scrub with brush again 10 times and let site for 15 mins
patches out and then run a wet patch back and forth and let sit for 10 mins
patch out and no blue seen run some oil covered patches through and leave till next time
if copper still present repeat brush 10 times etc

i also use JB or isso every 200 rounds to make sure no carbon in neck area

i have been using boretech eliminator  and carbon remover, pro shot but i have just started to test Helmar carbon and copper remover (aussie made and cheap as)
i must say the carbon remover is awesome stuff, the copper remover is doing a good job to but i'm still testing it atm and now i have 2 new barrels with no cracking i can test it properly now